A tub wheel can drive a vertical millstone shaft directly. This calculator evaluates entered flow and net head, applies an entered overall efficiency, and divides the resulting illustrative power by an independently chosen stone speed.
Water Wheel (form 5) Interactive Calculator
Enter net head, steady flow, assumed overall efficiency and chosen stone speed. Jet speed is ideal; efficiency and RPM are inputs, so shaft power and torque are illustrative rather than predicted.
Equation Used
- Water density is 1000 kg/m3 and g=9.81 m/s2.
- Entered flow and net head are steady and simultaneous.
- Jet speed is the lossless gravity value from net head.
- Overall efficiency and stone RPM are entered constants.
- Chute loss, runner geometry, splash, bearing loss curves, stone load, governing, structure and safety limits are omitted.
Tub-Wheel Flow and Head
The U.S. Department of Energy explains that hydropower depends on flow and head. The DOE Microhydropower Handbook provides the standard power equation and efficiency definition.
What This Calculator Represents
The tool evaluates one steady flow-head resource, a lossless jet-speed reference, an entered efficiency and an independently chosen direct-drive stone speed.
Flow, Head and Chosen Speed
P_h=rho g Q H
P_i=eta P_h
tau_i=P_i/omega
Efficiency and RPM are inputs, not predictions.
Worked Scenario
At 3 m net head and 50 L/s, ideal jet speed is about 7.7 m/s and gross hydraulic power about 1.47 kW. At 50% entered efficiency and 90 rpm, illustrative shaft power is about 0.74 kW and torque about 78 N m.
Model Boundary
- Calculated: ideal jet speed, steady flow-head power and conversions from entered efficiency/RPM.
- Illustrated: chute, tub runner, vertical shaft and direct-drive readouts.
- Not calculated: losses, actual efficiency/speed, runner or stone geometry, load equilibrium, governing, structure or safety.
Frequently Asked Questions
Is jet speed measured?
No; it is the lossless value from entered head.
Is efficiency predicted?
No.
Is stone speed solved?
No; it is entered.
Is torque guaranteed?
No; it is an illustrative quotient at the chosen speed.
Are chute and bearing losses modeled?
Only through the single entered efficiency.
Can this size a real mill?
No.
References
Building or designing a mechanism like this?
Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.