Water Wheel Form 2: Pitchback Animation and Power Calculator

← Back to Engineering Library

A pitchback wheel receives water near the upper quadrant so gravity contributes through the descending buckets. This calculator applies the standard flow-head power equation, then uses an explicit assumed 1.8 m/s rim speed to form an illustrative wheel-speed and torque operating point.

Pitchback Water Wheel Interactive Calculator

Enter flow, net head, assumed overall efficiency and wheel diameter. Power follows the flow-head equation; speed and torque use a fixed 1.8 m/s rim-speed assumption and are not a governor or load solution.

0°

Gross hydraulic power
--
Illustrative shaft power
--
Assumed-rim-speed wheel rate
--
Illustrative operating torque
--

Equation Used

hydraulic power=rho g Q H; illustrative shaft power=eta rho g Q H; assumed-speed rpm=60(1.8)/(pi D); illustrative torque=P/omega.
Use net head and measured flow. The entered efficiency is assumed. The 1.8 m/s rim speed is a declared scenario value, not derived from head, bucket geometry, load or field calibration; torque is the corresponding power/speed quotient.
  • Water density is 1000 kg/m3 and g=9.81 m/s2.
  • Q and net H are steady and simultaneously available.
  • Overall efficiency is entered and constant.
  • Rim speed is fixed at 1.8 m/s solely for the illustrative RPM and torque outputs.
  • Intake, spill, approach velocity, tailwater, bucket fill, leakage, load curve, drivetrain and structural limits are omitted.
Same mechanism and inputs as the interactive calculator.

Pitchback Wheel Flow and Head

The U.S. Department of Energy explains that hydropower depends on flow and head. The DOE Microhydropower Handbook gives the standard power equation and defines efficiency as actual output divided by theoretical power.

What This Calculator Represents

The tool calculates a steady gross hydraulic power and efficiency-scaled illustrative shaft power. Diameter only sets the RPM corresponding to the declared 1.8 m/s rim-speed scenario.

Flow, Head and Assumed Speed

P_h=rho g Q H
P_i=eta P_h
N=60(1.8)/(pi D)
tau_i=P_i/omega

N and torque are operating-point conversions, not a predicted equilibrium under load.

Worked Illustrative Point

At 0.12 m3/s, 4 m net head and 68% entered efficiency, gross hydraulic power is about 4.7 kW and illustrative shaft power is about 3.2 kW. A 4 m diameter at the declared 1.8 m/s rim speed corresponds to about 8.6 rpm and about 3.6 kN m.

Model Boundary

  • Calculated: ideal flow-head power, entered-efficiency output and fixed-rim-speed conversions.
  • Illustrated: pitchback admission, descending buckets and shaft-power readouts.
  • Not calculated: efficiency, actual wheel speed, bucket fill, losses, governing, load matching, structure or annual energy.

Frequently Asked Questions

Is 1.8 m/s calculated?

No; it is a fixed scenario assumption.

Does diameter change hydraulic power?

No; it only changes the assumed-speed RPM here.

Is efficiency predicted?

No; it is entered.

Is torque a guaranteed shaft value?

No; it is the illustrative power divided by the assumed angular speed.

Are flow and head constant?

Yes, by assumption.

Can this size a real wheel?

No.

References

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: