Pelton Water Wheel: Ideal Jet and Runner Kinematics

← Back to Engineering Library

A Pelton wheel extracts energy from a free water jet striking splitter buckets around its runner. Calculate ideal jet speed from net head, then explore how a selected speed ratio and runner diameter affect rpm. Enter an efficiency assumption to estimate shaft power.

Pelton Ideal-Kinematics Explorer

Enter net head, flow, runner pitch diameter, a selected rim-speed ratio and an assumed overall efficiency. The worksheet reports ideal jet speed, rim speed, runner rpm and assumption-based shaft power.

0°

Ideal jet speed
--
Runner rim speed
--
Assumed shaft power
--
Runner speed
--

Equation Used

v=sqrt(2gHnet); u=phi v; N=60u/(pi D); Passumed=eta rho g Q Hnet
Net head is the energy head available at the nozzle after upstream losses. The power result multiplies hydraulic power by the efficiency you enter; it is not a turbine-selection or guaranteed-output result.
  • Water density is fixed at 1000 kg/m^3 and g at 9.80665 m/s^2.
  • The nozzle converts the entered net head to ideal jet speed with coefficient 1.0.
  • Runner pitch diameter is the bucket-path diameter used for rpm conversion.
  • Speed ratio and total efficiency are declared user assumptions.
  • Jet diameter, bucket count, structural loads, generator matching, transients, cavitation, erosion, site design and safety are excluded.

The inputs update the numerical results. The schematic uses fixed wheel proportions and playback speed; it does not scale the drawn jet or runner to the entered dimensions. Efficiency and rim-speed ratio remain input assumptions.

Free jet, splitter buckets and an atmospheric runner

The U.S. Department of Energy classifies the Pelton as an impulse turbine for high-head, low-flow applications. One or more free jets discharge into an aerated space and strike buckets on the runner; no draft tube is required because the runner operates at atmospheric pressure.

An Idaho National Laboratory design report describes the nozzle converting head to free-jet velocity, the bucket splitter dividing the jet, and the bucket turning the flow to create torque.

High-head, lower-flow hydropower

DOE guidance says turbine selection depends on site head, flow, efficiency, cost and other site-specific constraints. Pelton machines are generally associated with very high head and lower flow.

This calculator explores declared ideal kinematics only; it does not select equipment or establish site feasibility.

Ideal jet and runner relations

v=sqrt(2gHnet); u=phi v; N=60u/(pi D)

Net head Hnet gives the ideal free-jet speed v. A selected ratio phi sets bucket rim speed u, and pitch diameter D converts that linear speed to rpm. Assumption-based shaft power is eta rho g Q Hnet.

Declared ideal example

With Hnet=120 m, Q=50 L/s, D=600 mm, phi=0.47 and assumed eta=90%, the ideal jet speed is 48.5 m/s, rim speed 22.8 m/s, runner speed about 725 rpm and assumption-based shaft power 53.0 kW.

Inputs are not a turbine performance map

The ideal velocity relation does not capture nozzle coefficient, windage, bucket losses, jet interference, generator efficiency or operating-point behavior. The entered efficiency is an assumption rather than a prediction.

Site feasibility and equipment selection require the actual water resource, losses and a manufacturer’s performance data. The calculator provides an ideal comparison for the entered conditions.

Pelton calculation questions

Is head gross or net?

Enter net head available at the nozzle after upstream losses.

Does the calculator determine efficiency?

No. Efficiency is an input assumption.

What diameter is used?

The runner pitch diameter at the bucket path.

Does this select a turbine or generator?

No.

Pelton references

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: