A mechanical watch going train transmits torque from the barrel through center, third and fourth wheel sets to the escape wheel. This calculator multiplies four entered stage speed ratios and converts an entered barrel period to ideal shaft speeds.
Watch Train Interactive Calculator
Enter four ideal stage speed ratios and barrel period. The visual shows a connected barrel-to-escape compound train with alternating external-mesh directions; outputs are no-loss kinematic conversions, not derived tooth geometry, movement identification, torque, wear or service guidance.
Equation Used
- All four ratios are entered positive speed-magnitude ratios.
- Barrel period is entered in hours per revolution and treated as constant.
- Stage ratios multiply with no slip, backlash or loss.
- Reported numeric speeds are magnitudes; the visual alternates direction at each external mesh.
- The connected pitch circles illustrate the entered ratios; individual tooth and leaf profiles are not drawn or calculated. Bearings, friction, torque, power, escapement locking, balance frequency, hands, tolerances, wear and movement-specific geometry are omitted.
Watch Going-Train Topology
U.S. Patent 6,612,734 describes a barrel, center wheel and pinion, third wheel and pinion, fourth wheel and pinion, and escape wheel and pinion in a mechanical timepiece. NASA gear-drive guidance discusses fixed speed ratios and integer gear teeth. These sources support topology and ratio arithmetic, not any particular entered values.
What This Calculator Represents
The tool treats each stage as an entered ideal speed ratio, multiplies the stages, and converts the entered barrel period into ideal speeds at selected train locations.
Ideal Compound-Ratio calculation
nbarrel=1/T rev/hr
ncenter=r1/T rev/hr
nfourth=r1 r2 r3/(60T) rpm
nescape=Rtotal/(60T) rpm
The displayed numerical speeds are positive magnitudes. The animation alternates direction at external meshes; losses and tooth geometry are not calculated.
Worked Ideal Example
For ratios 7, 8, 7.5 and 10 with a 7-hour barrel period, total speed ratio is 4,200. Ideal center speed is 1 rev/hr, fourth-wheel speed is 1 rev/min and escape-wheel speed is 10 rpm.
Assumptions and Limits
- Calculated: ideal ratio product and speed magnitudes from an entered barrel period.
- Illustrated: barrel-to-escape train sequence and relative rotation cues.
- Not calculated: tooth counts/profile, center distance, torque, loss, backlash, strength, escapement, balance frequency, hands, wear or movement identification.
Frequently Asked Questions
Are the ratios derived from tooth counts?
No; they are entered directly.
Does the calculator track direction?
No; outputs are positive speed magnitudes.
Is fourth-wheel speed always one rpm?
No; it depends on the entered ratios and barrel period.
Does escape speed determine balance beat rate here?
No; escape tooth count and escapement action are omitted.
Are friction and torque included?
No.
Can this identify or service a calibre?
No.
References
Building or designing a mechanism like this?
Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.