Stem-winding Movement Explained: Keyless Works Mechanism, Parts, and Crown-Turn Formula

← Back to Engineering Library

This partial calculator treats the selected tooth counts as an ideal two-stage compound train: an input winding pinion drives a crown wheel, a selected coaxial crown-wheel pinion drives a ratchet wheel, and the ratchet wheel is assumed to turn the selected barrel arbor. It reports ideal turn ratios only. It does not reconstruct or rate a watch movement.

Stem-Winding Movement - Ideal Two-Stage Gear-Ratio Ledger

Explore ideal turn ratios for an explicitly selected two-stage compound winding train.

0°

Required Ideal Input Turns
--
Ideal Input-to-Barrel Turn Ratio
--
Selected Stage 1 Ratio
--
Selected Stage 2 Ratio
--

Equation Used

R1=Z_cw/Z_wp; R2=Z_rw/Z_cp; G=R1 R2; N_input=N_barrel G.
Ideal selected compound gear train only; no actual movement, mainspring, torque, efficiency or safe winding limit.
  • The input winding pinion externally meshes with the selected crown wheel.
  • The selected crown wheel and selected crown-wheel pinion are rigidly coaxial.
  • The selected crown-wheel pinion externally meshes with the ratchet wheel.
  • The ratchet wheel and selected barrel arbor have equal turn count.
  • Tooth form, module, bevel geometry, losses, loads, mainspring behavior and safety are excluded.

The secondary figure is a proportional pitch-circle and angular-ratio schematic, not a watch layout or tooth design.

Same mechanism and inputs as the interactive calculator.

Selected two-stage winding-train ledger

For each ideal external gear mesh, input turns divided by output turns equals driven teeth divided by driver teeth. The two selected stage ratios multiply because the crown wheel and selected crown-wheel pinion are assumed fixed to one intermediate shaft. Required input turns equal selected barrel-arbor turns times the total reduction.

What the calculator determines

Use it to inspect the arithmetic of the explicitly assumed four-member compound train. The pitch-circle schematic preserves tooth-count proportions but is not a watch layout or tooth design.

Selected relationships

R1=Z_cw/Z_wp; R2=Z_rw/Z_cp; G=R1 R2=N_input/N_barrel; N_input=N_barrel G.

Selected-input example

For 7 selected barrel-arbor turns, 12-tooth input pinion, 30-tooth crown wheel, 24-tooth coaxial pinion and 48-tooth ratchet wheel, R1=2.5, R2=2, total ideal reduction G=5, and 35 input turns are required.

Not a watch-movement model

Actual topology, tooth form, module, pressure angle, bevel geometry, shaft spacing, click action, clutch or sliding pinion, winding direction, mainspring turns and torque, losses, wear, tolerances, lubrication, overwind protection and safety are excluded.

Questions

Why is a separate crown-wheel pinion assumed?

The source exposes a fourth tooth count named crown-wheel pinion. The candidate therefore evaluates the selected four-member compound topology explicitly; it does not claim every watch uses that arrangement.

Does this predict turns to fully wind a watch?

No. Selected barrel-arbor turns are an entered value, not a measured mainspring capacity or safe limit.

Are the drawn teeth a manufacturable profile?

No. The figure shows ideal pitch-circle proportions and angular ratios only.

Authoritative references

References & Further Reading

  • Wikipedia contributors. Keyless work. Wikipedia

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: