Recent Blogs
Proportional Dividers: Exact Similar-Triangle Scaling
How proportion compasses and hyperbola-drawing linkages work, with the geometry, real shop scenarios, and a worked example for pattern-makers and drafters.
Section Liner Mechanism: How the Pawl-and-Rack Indexing Works, Parts, Uses, and Hatching Formula
Section Liner explained — how draughtsmen use this drawing tool to hatch parallel section lines fast and consistently in mechanical and architectural drafting work.
Proportional Compasses: Exact Pivot Setting and Scale Transfer
Proportional Compasses scale drawings up or down with one slide adjustment. Learn the geometry, ratios, and real draughting uses from architects to model-makers.
Trammel for Drawing Ellipses: Semi-axes and Slider Span
Explore two sliders in perpendicular tracks. Convert ellipse diameters into semi-axes and ideal slider spans, with hardware clearance and fabrication tolerances excluded.
Tracing Bar: Guides, Pivots and Entered-value Comparisons
Explore how guides and pivots constrain a tracing bar. Add entered offsets, scale a length and convert units; the calculator does not solve the traced...
Flexible Curve Scriber: Drawing Guide and Elastic Comparison | FIRGELLI
Learn how a flexible drawing guide follows a contour. Compare ideal elastic bending moment and entered radii without predicting permanent set or damage.
Ellipsograph Turntable Mechanism: How It Works, Parts, Formula and Diagram Explained
Explore an extended-arm ellipsograph and compare guide clearance with load-scaled measured deflection. The ideal ellipse is separate from the fit comparison.
Eidograph Mechanism Explained: Parallel-Bar Drawing Copier, How It Works, Parts, Formula, Diagram
See how an eidograph’s equal pulleys, parallel arms and matched fulcrum position produce a scaled drawing. Compare copy length and area ratios.
Drawing Instrument (form) Mechanism: How It Works, Parts, Diagram & Error Calculator
Explore drawing-compass geometry and combine entered standard uncertainties. Compare drawing radius, circumference and equivalent full-size dimensions.
Cyclograph: Three-Rule Circular Arc Mechanism and Coordinate Calculator
See a three-rule cyclograph draw a circular arc using two fixed guide pins. Calculate radius, arc length and pencil coordinates from chord spacing and rise.
Three-part Parallel Ruler: Arm-length Mismatch Comparison
Explore the equal-arm parallel-ruler arrangement and compare three entered length mismatches. Percentages are dimensional comparisons, not angular-error predictions.
Centrolinead Mechanism Explained: How the Drafting Linkage Aims Lines at Off-Board Vanishing Points
See a rigid centrolinead slide against two fixed pins to draw toward a remote vanishing point. Compare pin bearings, arm settings and a separate line-deviation...
Parallel Ruler (Form 5): Hiscox Slotted Crossed Bars
Explore Hiscox’s slotted parallel ruler with equal crossed bars. Calculate ruler separation, sliding-end span and center-to-end distance from bar length and angle.
Parallel Ruler (Form 4): Ideal Repeated-Line Transfer
Explore repeated transfers with an equal-link parallel ruler. Calculate perpendicular step size, full placement count, covered distance and final excess.