Marine Dredge: Cutter-Suction Flow and Solids Accounting

← Back to Engineering Library

A cutter-suction dredge loosens material at the cutterhead and pumps the water-solids mixture through a discharge pipeline. Explore the cutter, ladder pump and spud pivot, then calculate slurry and dry-solids flow at one measured pipe section.

Cutter-Suction Pipeline Flow Calculator

Enter inside pipe diameter, measured average slurry velocity, measured solids volume fraction and dry particle density. Results are ideal instantaneous flow accounting, not a production guarantee or operating setpoint.

0°

Pipe flow area
--
Ideal slurry flow
--
Dry-solids volume flow
--
Dry-solids mass flow
--

Equation Used

A=pi D^2/4; Q=3600 A v; Q_s=C_v Q; m_s=rho_s Q_s
D is inside diameter, v is cross-section-average slurry velocity, Cv is the measured solids volume fraction and particle density uses t/m3. Downtime, bulking, voids, overflow, deposition, leakage and survey-volume conversion are excluded.
  • The circular pipeline is full and diameter and average velocity refer to the same measurement section.
  • Solids volume fraction and dry particle density are independently measured or specified for the same material stream.
  • Outputs are ideal instantaneous line-flow quantities and not in-situ excavation or delivered production.

Use diameter, average velocity, solids concentration and particle density from the same full-pipe material stream. The results describe instantaneous line flow; they do not account for downtime or predict delivered excavation volume.

Cutter, suction ladder, pump and discharge pipeline

A cutter-suction dredge loosens the bed at a rotating cutterhead. The dredge pump draws the water-solids mixture into the suction pipe and sends it through the floating or shore discharge pipeline. Spuds anchor the hull and provide a pivot for successive swing cuts.

The animation shows those components and the slurry path schematically. It is not a pump curve, soil-cutting or pipeline-deposition model.

One measured line-flow operating point

Use the calculator to convert a measured full-pipe diameter and mean velocity into slurry flow, then apply a measured solids volume fraction and particle density. Delivered and in-situ production require project-specific survey, operating-time, loss and material-volume accounting.

Full-pipe continuity and solids accounting

A=pi D2/4; Q=3600Av; Qs=CvQ; ms=rhosQs

The factor 3600 converts cubic metres per second to cubic metres per hour. Particle density must not be confused with wet bulk or in-situ density.

Arithmetic example

For D=700 mm, v=5.0 m/s, Cv=20% and rho=2.65 t/m3, area is 0.385 m2, ideal slurry flow is 6,927 m3/h, dry-solids volume flow is 1,385 m3/h and dry-solids mass flow is 3,671 t/h.

Model boundary

Real dredge production depends on the cutter/soil interaction, pump and pipeline curves, deposition behavior, losses, downtime, overflow, surveys and material state.

Dredge flow questions

Is this delivered production?

No. It is ideal instantaneous flow through one measured pipe section.

Why use particle density?

Multiplying dry-solid volume by dry particle density gives dry-solid mass. In-situ or wet bulk density is a different property.

Does the calculator set minimum transport velocity?

No. Deposition velocity depends on particle distribution, concentration, pipe geometry and slurry properties and requires a dedicated hydraulic model.

USACE references

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: