Z-crank Engine Mechanism: How It Works, Diagram, Parts, Uses, and Secondary Couple Formula

← Back to Engineering Library

This simplified engine model compares two crank-slider rows in separate axial planes. Explore the estimated secondary inertia force and couple from reciprocating mass, stroke, rod length, offset and speed.

Z-crank Engine Interactive Calculator

Enter reciprocating mass, stroke, rod-to-stroke ratio, axial offset and speed. Compare the approximate secondary force, its offset couple, second-order frequency and rod length.

0°

Calculated peak couple
--
Calculated 2nd-order force
--
Calculated vibration freq.
--
Calculated rod length
--

Equation Used

Crank radius r = stroke / 2. Rod length L = entered rod-to-stroke ratio × stroke. Angular speed ω = 2π × rpm / 60. Approximate secondary force = mass × r × ω² × (r/L). Couple indicator = secondary force × entered offset. Second-order frequency = 2 × rpm / 60. Use SI units for force and couple.
The force relation is a simplified inertia approximation. It excludes gas pressure, distributed rod mass, bearings, structural flexibility, combustion, higher-order terms and complete engine balancing. The displayed couple is an estimate, not a vibration or durability prediction.
  • Inputs are user-supplied scenario values.
  • The displayed equations are evaluated directly.
  • Entered efficiencies, shares, limits and factors are not predicted.
  • The visual is schematic and not dimensional.
  • Strength, fatigue, wear, variation, controls and safety compliance are omitted unless explicitly calculated.
Watch the Z-crank Engine in motion
Video: Gear slider crank mechanism 1 by Nguyen Duc Thang (thang010146) on YouTube. Used here to complement the diagram below.
Same mechanism and inputs as the interactive calculator.

How the Z-crank Engine Works

The schematic shows the two reciprocating rows and their phasing. The calculator uses a secondary-force approximation; it does not model gas forces, combustion or the complete engine balance.

What This Calculator Represents

The force relation is a simplified inertia approximation. It excludes gas pressure, distributed rod mass, bearings, structural flexibility, combustion, higher-order terms and complete engine balancing. The displayed couple is an estimate, not a vibration or durability prediction.

Calculation Method

Crank radius r = stroke / 2. Rod length L = entered rod-to-stroke ratio × stroke. Angular speed ω = 2π × rpm / 60. Approximate secondary force = mass × r × ω² × (r/L). Couple indicator = secondary force × entered offset. Second-order frequency = 2 × rpm / 60. Use SI units for force and couple.

How to Read the Result

Change one input at a time to compare its effect. Apply the assumptions stated beside the equations when interpreting each result.

Assumptions and Limits

The force relation is a simplified inertia approximation. It excludes gas pressure, distributed rod mass, bearings, structural flexibility, combustion, higher-order terms and complete engine balancing. The displayed couple is an estimate, not a vibration or durability prediction.

Frequently Asked Questions

Does the force estimate predict engine vibration?

No. Actual vibration also depends on the complete moving system, phasing, structure, mounts and damping.

How is rod length obtained?

The entered rod-to-stroke ratio is multiplied by the stroke. The calculator then uses that rod length in the secondary-force approximation.

Is the drawing suitable for manufacturing?

No. It is a schematic explanation and does not specify manufacturing dimensions, tolerances or materials.

Do these results establish safe operating limits?

No. Assess the complete equipment, loads, materials, controls and applicable requirements separately.

References

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: