Watch-Winding Stop Form 3: Animation and Turn-Count Calculator

← Back to Engineering Library

A watch winding stop can count relative barrel-arbor revolutions with an intermittently advanced wheel and block further winding at a limiting feature. This calculator compares entered turn/count references only.

Watch-winding Stop Form 3 Interactive Calculator

Enter two turn references and an assumed finger advance per arbor revolution. Outputs are arithmetic references—not a derived winding limit, star-wheel geometry, mainspring reserve or torque rating.

0°

Midpoint turn reference
--
Entered turn-reference span
--
Midpoint step reference
--
Cumulative arbor rotation
--

Equation Used

ordered limits lo=min(N1,N2), hi=max(N1,N2); midpoint=(lo+hi)/2; span=hi−lo; step reference=midpoint a; cumulative arbor rotation=360 midpoint.
The final angle is cumulative arbor rotation, not the angular position of a physical stop feature. The midpoint is only the average of two entered references and is not an engineering-selected limit.
  • Both turn references are user-entered and reordered low to high.
  • The nominal value is their arithmetic midpoint, not a derived design setting.
  • Advance per revolution is entered independently and multiplied by the midpoint.
  • Cumulative arbor rotation is 360 degrees per turn and may exceed one revolution.
  • Actual indexing geometry, integer slots/teeth, contact, locking, barrel/drum relative motion, mainspring turns, torque, reserve, strength and wear are omitted.
Same mechanism and inputs as the interactive calculator.

Indexed Winding-Stop Topology

U.S. Patent 6,439,762 describes a finger fixed to a barrel arbor advancing a Maltese-cross-type gear one tooth per arbor revolution until a flat tooth blocks winding. That topology does not establish this page's entered turn values.

What This Calculator Represents

The tool orders two entered turn references, reports midpoint and span, multiplies the midpoint by an entered advance ratio, and converts it to cumulative arbor degrees.

Entered Turns and Advance Counts

midpoint=(lo+hi)/2
span=hi−lo
step reference=midpoint a
cumulative rotation=360 midpoint

These arithmetic results do not determine the geometry or operating limit of a physical stop.

Worked Arithmetic Example

For entered turn references four and six with one step per revolution, midpoint is five turns, span is two turns, step reference is five and cumulative arbor rotation is 1,800 degrees.

Model Boundary

  • Calculated: ordered midpoint/span, a product with entered advance and cumulative turns-to-degrees conversion.
  • Illustrated: generic finger and indexed wheel sequence.
  • Not calculated: physical stop geometry, discrete feasibility, contact, mainspring reserve, torque, strength or movement compatibility.

Frequently Asked Questions

Is the midpoint a recommended winding limit?

No.

Is cumulative arbor rotation a stop-feature angle?

No.

Must the step reference be an integer?

A physical indexed wheel normally requires discrete geometry, but this arithmetic tool does not enforce it.

Are mainspring turns or reserve predicted?

No.

Does the visual solve contact?

No.

Can this design a winding stop?

No.

References

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: