Spiral Hoop Gear Mechanism Explained: Helical Girth Ring, Pinion Drive, Diagram and Calculator

← Back to Engineering Library

This partial calculator keeps only selected helix-dimension identities. It does not represent the cited Archimedean spiral gear and pin rack, establish a helical hoop gear, or predict tooth contact and load sharing.

Partial · Selected Helix-Dimension Ledger

Compare selected angle, face-width and pitch dimensions without claiming a gear topology or tooth contact.

0°

Selected Face/Pitch Spans
--
Nominal Lateral Offset
--
Selected Angle
--
Selected Slope
--

Equation Used

spans=b/p; offset=b tan beta; radians=beta pi/180; slope=tan beta.
Selected dimension identities only; no Archimedean spiral, hoop-gear contact, load sharing or thrust model.
  • Values are selected nominal dimensions.
  • Angle is measured on a flat dimension strip.
  • Gear topology, tooth form, contact, load and strength are excluded.

The figure is a dimension strip, not a gear mesh.

Watch the Spiral Hoop Gear in motion
Video: Archimedean spiral gear and Pin rack by Nguyen Duc Thang (thang010146) on YouTube. Used here to complement the diagram below.
Same mechanism and inputs as the interactive calculator.

Supported dimension arithmetic

For selected face width b, circular pitch p and angle beta, transverse face spans are b/p, nominal lateral offset is b tan beta, angle in radians is beta pi/180 and slope is tan beta.

Use and boundary

Use only as a selected geometry ledger before choosing and defining a real gear topology.

Selected identities

spans=b/p; offset=b tan beta; radians=beta pi/180; slope=tan beta.

Default example

For beta=8 degrees, b=600 mm and p=56.2 mm, the selected face spans about 10.68 pitches and the nominal offset is about 84.32 mm.

Unsupported mechanism and load claims removed

Nominal contact ratio, equally loaded teeth and axial-thrust claims were removed.

Questions

Is this a contact-ratio calculation?

No.

Does it reconstruct the source video?

No.

References

References & Further Reading

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: