This partial calculator is a selected external gear-pair tooth-count ledger. It does not identify the cited Spiral V-gearing mechanism or predict spiral-bevel contact, thrust or load capacity.
Partial · Selected External Gear-Pair Ratio Ledger
Compare selected external gear tooth counts without inventing spiral contact or thrust.
Equation Used
- An ordinary external gear pair is selected for arithmetic only.
- Tooth counts are positive.
- Pitch cones, tooth hand, contact, thrust, load and capacity are excluded.
The figure is a tooth-count ledger, not spiral-bevel geometry.
Supported selected gear-count arithmetic
For a deliberately selected external gear pair, ratio is Ng/Np, driven turns are input turns times Np/Ng, and the gears rotate in opposite directions.
Use and boundary
Use this ledger only after selecting an ordinary external gear-pair interpretation. It is not a reconstruction of the cited source.
Tooth-count identities
ratio=Ng/Np; reciprocal=Np/Ng; driven turns=input turns times Np/Ng.
Default example
For 11 and 41 teeth with one selected input turn, ratio is 3.7273 and driven rotation is about 0.2683 turn opposite the input.
Unsupported gear claims removed
Spiral angle, contact ratio, axial thrust and decorative contact paths were removed because the source topology and tooth geometry are unresolved.
Questions
Does this model spiral bevel contact?
No.
Does it identify Spiral V-gearing?
No.
References
References & Further Reading
- Wikipedia contributors. Spiral bevel gear. Wikipedia
Building or designing a mechanism like this?
Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.