Lever Chronometer Escapement: Hiscox Item 1185 Phase Viewer

← Back to Engineering Library

Hiscox item 1185 identifies four qualitative relationships in this lever chronometer escapement; the undimensioned plate does not support timing or restoration calculations.

Lever Chronometer Escapement Phase Viewer

Select a qualitative phase from the historical caption. The undimensioned drawing does not calculate impulse angle, free arc, rate, beat error or service tolerances.

0°

Selected phase
--
Legend position
--
Source relationships
--
Timing predictions
--

Equation Used

phase index n=1..4; cycle position=(n-1)/3 times 100 percent
This is an ordered phase legend, not contact geometry or a timing model.
  • The drawing follows the qualitative topology of Hiscox item 1185.
  • Lock, pin-entry, lever-throw and single-pallet impulse are shown as named phases only.
  • No tooth profile, jewel geometry, clearance, drop, draw, timing, rate or restoration tolerance is inferred.

This historical viewer identifies four qualitative relationships and does not predict timing or restoration tolerances.

Relationships stated by Hiscox

Item 1185 identifies single-pallet impulse, alternating lock by lever throw, an oscillating pin entering the lever fork and the lever moving against stop pins.

Historical interpretation only

The viewer helps identify those relationships in the plate. It is not a movement design, adjustment or restoration guide.

A phase legend, not an impulse calculation

n=1..4; legend position=(n-1)/3 times 100 percent

Total balance arc divided by impulse count is not an impulse angle; the displayed percentage is only the selected phase's position in the four-item legend.

Four qualitative selections

Select lock, pin entry, lever throw or single-pallet impulse. Highlighting does not claim exact contact timing.

Undimensioned historical source

The plate does not provide tooth, jewel, fork or stop dimensions needed for a contact-constrained reconstruction.

Phase-viewer questions

Does this calculate beat error or rate?

No.

Can it guide adjustment?

No.

Is the sequence dimensioned?

No.

Historical reference

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: