A water turbine converts hydraulic power from flow and net head into shaft power. This calculator evaluates hydraulic power with an explicitly assumed gate-efficiency schedule; it does not reproduce a tested Warren central-discharge turbine map.
Warren Central Discharge Turbine Interactive Calculator
Enter net head, flow, full-gate efficiency, gate index and shaft speed. Results use a disclosed assumed efficiency schedule—not a measured turbine map, operating envelope, cavitation, generator or structural model.
Equation Used
- Water specific weight is fixed at 62.4 lbf/ft³.
- Entered head is treated as net head and entered flow as turbine flow.
- Full-gate efficiency is entered.
- Gate efficiency follows the disclosed two-line interpolation through 0%, 55% at half gate and entered full-gate efficiency.
- Shaft speed is entered independently of head, flow and runner geometry.
- Runner dimensions, velocity triangles, gate geometry, losses, test curves, cavitation, draft tube, transients, runaway, torque-speed coupling, generator, controls, structure and safety are omitted.
Hydraulic Power and Efficiency
The U.S. Bureau of Reclamation Engineering Monograph 20 gives turbine output in U.S. customary units from flow, head and efficiency. Reclamation also notes in hydropower modeling that efficiency may vary with release and head. This page's piecewise gate schedule is only a transparent assumption.
What This Calculator Represents
The tool calculates available hydraulic power from entered net head H and flow Q, applies an assumed gate-efficiency interpolation, and converts estimated shaft power at entered rpm to torque.
Hydraulic Power with Assumed Gate Schedule
etaSchedule=piecewise disclosed interpolation
Pshaft=Pwater etaSchedule
torque=5252Pshaft/N
The efficiency schedule is not a measured turbine map.
Worked Arithmetic Example
For H=30 ft, Q=1 cfs, entered full-gate efficiency 78%, full gate and 250 rpm, water power is 3.40 hp, schedule efficiency is 78%, shaft-power estimate is 2.65 hp and torque estimate is 55.7 lb-ft.
Model Boundary
- Calculated: general water power, assumed efficiency schedule, estimated shaft power and power-derived torque.
- Illustrated: generic radial inflow and central-discharge runner cue.
- Not calculated: a Warren geometry, measured map, cavitation, draft tube, speed coupling, runaway, generator, controls, structure or safety.
Frequently Asked Questions
Is the gate-efficiency curve measured?
No.
Is 55% at half gate universal?
No; it is an assumption.
Is rpm predicted from head?
No; it is entered.
Are cavitation and draft-tube losses included?
No.
Is electrical output calculated?
No.
Can this rate or operate a turbine?
No.
References
Building or designing a mechanism like this?
Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.