Spirograph Mechanism Explained: Hypotrochoid and Epitrochoid Curves, Parts, Formula, and Uses

← Back to Engineering Library

A hypotrochoid is the locus of a point fixed at offset d from the centre of a circle of radius r rolling without slip inside a fixed circle of radius R. This calculator uses selected integer radii in one common length unit and reports exact closure and radial-repetition counts for that ideal construction.

Spirograph · Selected Hypotrochoid Geometry

Explore an ideal hypotrochoid from selected commensurate integer radii and a tracing-point offset.

0°

Selected Radius Ratio R/r
--
Closure Centre Orbits
--
Radial Repetitions
--
Selected Offset Ratio d/r
--

Equation Used

x=(R−r)cosθ+d cos((R−r)θ/r); y=(R−r)sinθ−d sin((R−r)θ/r); closure=r/g; radial repetitions=R/g.
R, r and d use one common selected length unit; R>r. Exact ideal no-slip geometry only.
  • R and r are positive commensurate integer radii in the same selected length unit.
  • The rolling circle remains in ideal no-slip contact inside the fixed circle.
  • The tracing point is rigidly attached at offset d, which may be smaller than, equal to or larger than r.
  • Closure is measured in centre orbits around the fixed-circle centre.
  • Tooth form, backlash, clearance, friction, pen compliance, drawing error and manufacture are excluded.

Former tooth-count language and the incorrect (R−r)/g lobe label are removed. The inputs are selected integer radii, and R/g is reported as radial repetitions.

Same mechanism and inputs as the interactive calculator.

Inside rolling without slip

The rolling-circle centre follows radius R−r. The attached point rotates relative to that centre by (R−r)θ/r, producing the plotted hypotrochoid.

What the calculator determines

Select commensurate integer radii R and r and point offset d. The diagram plots one complete ideal curve and shows the rolling circle and tracing point at the animation position.

Exact selected ledger

x=(R−r)cosθ+d cos((R−r)θ/r); y=(R−r)sinθ−d sin((R−r)θ/r). With g=gcd(R,r), closure requires r/g centre orbits and the radial pattern repeats R/g times.

Selected-input example

For R=150, r=50 and d=35 in one common length unit, g=50. The curve closes after one centre orbit and has three radial repetitions.

Ideal geometry only

The model assumes exact radii and no slip. It does not predict tooth form, backlash, clearance, friction, drawing error, pen compliance or manufacturability.

Questions

Why was the former lobe count changed?

The earlier (R−r)/g value is the reduced rolling-spin numerator, not the number of radial repetitions. The plotted curve repeats radially R/g times.

Are the inputs tooth counts?

No. They are selected integer radii in one common length unit. A physical geared instrument additionally requires compatible pitch geometry.

References & Further Reading

  • Wikipedia contributors. Spirograph. Wikipedia

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: