Gardner D. Hiscox's movement 600 shows variable compensating weights for a hydraulic lift, with weights picked up one after another. This calculator is a separate ideal static pressure calculation based on entered mass, ram area and fluid-reference depth.
Variable Compensating Weights Interactive Calculator
Enter ram diameter, primary mass, mass per stack, an engaged-stack count and downward fluid-reference depth. Results are ideal static arithmetic—not an accumulator, lift, structure, seal, control or safety design.
Equation Used
- The ram is circular and its entered diameter defines the full effective pressure area.
- The entered stack count is rounded to an integer and treated as already supported; animation phase does not change it.
- All supported masses act vertically under standard gravity.
- Fluid density is fixed at 870 kg/m^3 and h is a downward elevation difference from ram to delivery reference.
- The per-stack value assumes each stack has the same entered mass.
- Seal friction, guide friction, piston/rod area differences, acceleration, compressibility, pipe loss, leakage, structural loads, controls, capacity, stability and safety are omitted.
Hiscox Movement 600
Gardner D. Hiscox identifies movement 600 as variable compensating weights for a hydraulic lift and states that the weights are picked up one after another. The illustration here preserves that sequential pick-up topology without claiming dimensions, timing or a particular installation.
What This Calculator Represents
The tool totals an entered primary mass and entered number of identical stacks, divides their ideal weight by entered ram area and adds the hydrostatic pressure at an entered lower fluid reference. It separately reports the pressure contribution of one entered stack.
Ideal Static Pressure Calculation
supported mass M = m0 + n ms
ram-reference pressure = Mg / A
lower-point head = rho g h
lower-reference pressure = Mg/A + rho g h
pressure per stack = ms g/A
NIST's hydrostatic relation shows that pressure increases with depth below a reference. This page fixes oil density at 870 kg/m³ and uses standard gravity.
Worked Ideal Example
For a 350 mm ram, 50 tonne primary mass, two 10 tonne stacks and a lower reference 6 m below the ram, entered supported mass is 70.0 tonne. Ideal pressure per stack is 147.8 psi, hydrostatic head adds 7.4 psi and ideal lower-reference pressure is 1042.3 psi.
Model Boundary
- Documented and illustrated: weights picked up one after another for a hydraulic lift.
- Calculated: ideal static mass-over-area pressure and hydrostatic addition at a lower point.
- Not calculated: pick-up timing or height, seal and guide friction, moving dynamics, pipe loss, accumulator volume, stroke, structure, controls, capacity, stability, fatigue or safety.
Frequently Asked Questions
Does animation phase change the entered stack count?
No. The count is an entered static state.
Why is fluid head added?
The delivery reference is below the ram reference, so hydrostatic pressure increases by rho g h.
Is seal friction included?
No. The calculation uses supported weight divided by ram area and adds fluid head. Seal friction and other losses are not modeled.
Is oil density adjustable?
No; it is fixed at 870 kg/m³.
Does pressure per stack include head?
No. It is only the ideal added mass weight divided by ram area.
Can this size or approve a real lift?
No.
References
- Gardner D. Hiscox, Mechanical Movements, Powers, Devices and Appliances, movement 600: variable compensating weights for a hydraulic lift.
- NIST hydrostatic-pressure reference: pressure variation with density, gravity and elevation.
- U.S. Navy training material reproduced by Engineering Library: pressure, force, area and liquid-head relations.
Building or designing a mechanism like this?
Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.