Oblique Spur and Bevel Gear: Hiscox Mixed Gear Pair

← Back to Engineering Library

Hiscox item 132 pairs an oblique-tooth spur gear with an oblique bevel gear to transmit rotation between angular shafts. Explore the mixed gear forms and calculate an ideal tooth-count ratio and nominal reference diameters.

Mixed-Gear Tooth-Count Calculator

Enter declared driver and driven tooth counts, nominal module and a schematic shaft angle. The worksheet reports ideal tooth-count ratio and nominal reference diameters only; it does not generate the oblique spur or bevel tooth surfaces or rate a drive.

0°

Nominal spur reference diameter
--
Nominal bevel reference diameter
--
Driven rev per driver rev
--
Reduction magnitude
--

Equation Used

n2/n1=-z1/z2; i=z2/z1; dspur=m z1; dbevel=m z2
Hiscox supplies no dimensions, tooth-system definition or offset. The entered angle changes the schematic only; nominal d=mz values are reference diameters rather than a complete mixed-gear geometry.
  • The two declared tooth counts define one ideal external-mesh ratio with opposite rotation.
  • Nominal reference diameters use the entered module identity d=mz.
  • The source establishes an oblique-tooth spur gear, oblique bevel gear and angular shaft relation; the entered angle is illustrative.
  • Tooth hand, helix/spiral angles, pitch cones, apex, offset, mounting distance, pressure angle, face width, undercut, interference, backlash, contact pattern, losses, lubrication, loads, bearings, strength, manufacture and safety are excluded.

The tooth counts determine the ideal rotation ratio. The shaft-angle control changes the schematic, while complete tooth geometry and drive capacity remain outside the calculation.

An oblique-tooth spur gear meshes with an oblique bevel gear

Hiscox item 132 gives a concise topology: an oblique-tooth spur gear and an oblique bevel gear operate shafts running at an angular position. The plate shows the mixed gear forms and their shafts.

The schematic shows the two gear forms and their ideal tooth-count motion; tooth contact is not calculated.

A historical power-transmission arrangement

The arrangement illustrates power transmission through two different gear forms on angular shafts. A working application requires a defined tooth system, mounting geometry and load data beyond the ratio calculation.

Tooth-count ratio and nominal diameters

n2/n1=-z1/z2; i=z2/z1; dspur=mz1; dbevel=mz2

These identities do not solve the oblique tooth traces, bevel pitch surface, mounting position or contact geometry.

Declared tooth-count example

For z1=18, z2=36 and m=3 mm, nominal reference diameters are 54 and 108 mm. The bevel gear turns -0.500 revolution per spur revolution, an ideal 2.000:1 reduction magnitude. The 60° shaft angle is schematic only.

Reference dimensions and tooth geometry

Tooth counts and nominal module establish the displayed reference values, but do not generate the oblique tooth traces or bevel pitch surface. Suitable contact and mounting positions require a defined gear geometry; strength and operating limits require additional engineering data.

Mixed spur-and-bevel questions

Is this a hypoid axle design calculator?

No.

Does the shaft angle determine the ratio?

No. This ideal rotation ratio comes from the entered tooth counts.

Are the entered dimensions historical?

No.

Oblique spur-and-bevel reference

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: