Marshall Valve Gear: Suspension-Link Topology and Eccentric Motion

← Back to Engineering Library

Marshall radial valve gear uses a suspension link to guide the eccentric rod along an arc. Explore that arrangement and calculate the driving eccentric center displacement, speed and acceleration from throw, shaft speed and angle.

Marshall Gear Driving-Eccentric Calculator

Enter eccentric throw, shaft speed and shaft angle. Suspension setting changes the qualitative linkage drawing only; valve travel, lap, lead and cutoff require the complete as-built geometry and are not inferred.

0°

Eccentric center stroke
--
Instantaneous offset
--
Offset speed magnitude
--
Instantaneous acceleration
--

Equation Used

x=e cos(theta); v=-e omega sin(theta); a=-e omega^2 cos(theta); stroke=2e
The outputs describe the eccentric center relative to the shaft axis, not the slide valve. Link lengths, suspension pivots, valve lap/lead, port geometry, angularity, clearances and elastic deflection are excluded.
  • The eccentric rotates at constant entered speed and its center follows a circle of radius e.
  • Angle theta is measured from maximum positive eccentric offset.
  • Suspension setting is a normalized illustration control only and is not mapped to cutoff or valve travel.

The eccentric center follows a circular path, giving a sinusoidal projection along the selected axis. The suspension setting changes the illustrative linkage; calculating actual valve travel and events requires the complete engine geometry.

Modified Hackworth guide with a suspension link

Historical engineering references describe Marshall gear as a radial valve gear derived from Hackworth. A single driving eccentric moves the eccentric rod. Instead of constraining its guide point in a straight slot, Marshall gear uses a suspension link so that point follows a circular arc; moving the suspension geometry reverses and varies the valve events.

The animation identifies the eccentric, rod, suspension link and valve rod qualitatively. It does not solve an undocumented engine's valve motion.

Historical topology and driving-eccentric identities

Use the calculator to inspect the exact circular motion of a specified eccentric. Valve setting requires the complete engine drawing, measured pin centres, link lengths, lap, lead, ports and a full kinematic/valve-event analysis.

Exact rotating-eccentric component

x=e cos(theta); v=-e omega sin(theta); a=-e omega2 cos(theta); stroke=2e

These are the projected motion, velocity and acceleration of the eccentric center only. Downstream valve motion is not generally a linear multiple of suspension setting.

Arithmetic example

For e=70 mm, n=60 rpm and theta=45 degrees, eccentric stroke is 140.0 mm, projected offset is 49.5 mm, speed magnitude is 311.0 mm/s and acceleration is -1,954.1 mm/s2. None of these values is labeled valve travel.

Model boundary and name ambiguity

Other mechanisms also carry the Marshall name, including James Thompson Marshall's later two-eccentric patent, and should not be conflated with the Marshall/Hackworth radial gear represented here.

Marshall-gear questions

Does suspension percentage equal valve-travel percentage?

No. Complete linkage geometry must be solved.

Does the calculator predict cutoff?

No. Cutoff also depends on valve lap, lead, port geometry and piston/crank relationship.

Why calculate eccentric motion?

Throw, shaft speed and shaft angle define the eccentric center motion directly. Valve motion also depends on the downstream links, pivots and valve geometry.

Historical references

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: