Single Eccentric Reversing Gear: How It Works, Diagram, Parts, Formula and Uses Explained

← Back to Engineering Library

This partial calculator keeps only the ideal projection of a rotating eccentric and constant-speed identities. It does not reconstruct the named reversing gear because the source does not define the gab, slip link, lever ratio, valve connection or engagement geometry.

Partial · Ideal Eccentric Projection Reference

Explore ideal eccentric projection and constant-speed identities without inventing a reversing or valve linkage.

0°

Selected Projection
--
Full Ideal Stroke
--
Cycle Period
--
Peak Projection Speed
--

Equation Used

x=r cos(theta); stroke=2r; T=60000/n; v_max=(2 pi n/60)r.
Ideal eccentric projection only; no reversing engagement or valve-event model.
  • The eccentric rotates uniformly.
  • Displacement is the ideal projection on one selected axis.
  • Stroke means the peak-to-peak ideal projection, twice eccentric radius.
  • Gab, slip-link, levers, valve connection, lap, lead, port events, forces, wear and safety are excluded.

The secondary figure is a projection schematic, not a single-eccentric reversing-gear reconstruction.

Watch the Single Eccentric Reversing Gear in motion
Video: Gear rack drive for reversing rotation 1 by Nguyen Duc Thang (thang010146) on YouTube. Used here to complement the diagram below.
Same mechanism and inputs as the interactive calculator.

Supported eccentric projection

For an ideal eccentric of radius r, the projection on a selected axis is x=r cos(theta). Its peak-to-peak projection is 2r. At uniform shaft speed n, angular speed is omega=2 pi n/60 and the maximum projection speed is omega r.

This generic eccentric identity does not establish valve travel where a lever or reversing linkage intervenes.

Use and boundary

Use the reference to check eccentric radius, projected displacement, full ideal stroke, cycle period and peak projection speed. Do not use it to set a reversing gear, valve events, lap, lead or port opening.

Ideal projection identities

x=r cos(theta); stroke=2r; T=60000/n; v_max=(2 pi n/60)r.

Default selected-value example

At r=6 mm, n=60 rpm and theta=90 degrees, selected displacement is 0 mm, full ideal stroke is 12 mm, cycle period is 1000 ms and peak projection speed is about 37.70 mm/s.

Unsupported reversing claims removed

The former 2e+2lap valve-travel expression and e-lap+lead opening expression were removed because the page did not define a lever construction, angular datum or valve-event geometry. The visual intentionally omits the unresolved reversing topology.

Questions

Is projected displacement valve displacement?

Not necessarily. It is only the ideal projection coordinate of the eccentric.

Does this model forward and reverse engagement?

No. A gab or slip-link construction is not defined.

Does lap or lead change eccentric stroke?

No such relationship is asserted here.

References

References & Further Reading

  • Wikipedia contributors. Stephenson valve gear. Wikipedia

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: