Mangle Wheel: Guided Pinion and Oscillating Wheel

← Back to Engineering Library

A mangle wheel reverses its rotation as a continuously turning pinion passes between its outer and inner tooth tracks. Explore the guided-pinion arrangement and convert entered engagement counts into ideal sweep timing.

Ideal Mangle-Wheel Engagement Counter

Enter pinion speed, pinion tooth count, assumed engagement pitches per one-way sweep and an entered output sweep angle. Results are ideal count conversions, not a complete gear-motion or machine-rating model.

0°

One-way sweep rate
--
Full-cycle time
--
Average sweep speed
--
Pinion revolutions per sweep
--

Equation Used

f_sweep=n z/N; T_cycle=120/f_sweep; omega_avg=theta f_sweep/60; rev_sweep=N/z
N is an entered count of pinion-tooth engagement pitches per one-way sweep. The formulas do not derive N or sweep angle from wheel radii, tooth geometry or the guide groove, and do not represent unequal inner/outer speed.
  • The pinion speed and tooth count are constant and each revolution advances z ideal engagement pitches.
  • The entered N applies to each one-way sweep, and a full cycle contains two sweeps.
  • The visual crossover and guide track are schematic and not manufacturable tooth geometry.

Enter the engagement-pitch count and output sweep for the mechanism being studied. The counter converts these values into sweep rate and timing; it does not derive tooth profiles, guide geometry or the unequal speeds of different track radii.

Watch the Mangle Wheel in motion
Video: Mangle Wheel & Pinion on YouTube. Used here to complement the diagram below.

Guided pinion, outer track, crossover and inner track

Historical mangle-wheel illustrations show a pinion turning continuously in one direction while its shaft follows a guide groove in the wheel. The pinion works around one tooth circle, crosses at an end, and returns along the other, causing the wheel to reverse its direction of rotation.

The animation identifies those states schematically. It does not generate tooth profiles, guide-groove geometry or a complete constraint solution.

Historical topology and count conversion

Use the calculator only when the engagement-pitch count and output sweep are independently known for the mechanism being studied. It cannot select, size, rate, repair or diagnose a mangle wheel.

Declared engagement-count arithmetic

fsweep=n z/N; Tcycle=120/fsweep; revsweep=N/z

Average angular speed is the entered sweep angle multiplied by one-way sweeps per second. A full cycle contains an outward and return sweep. This arithmetic does not derive the mechanism geometry.

Arithmetic example

For n=60 rpm, z=12 teeth, N=36 entered pitches per sweep and theta=120 degrees, the ideal count gives 20 one-way sweeps/min, a 6.00 s full cycle, 40.0 deg/s average sweep speed and 3.00 pinion revolutions per sweep.

Model boundary

The entered engagement count and sweep angle are independent assumptions, not dimensions derived from a gear design. Brown explicitly notes that some mangle-wheel forms have unequal forward and reverse speeds because their tooth-circle radii differ.

Mangle-wheel model questions

Does the calculator derive the sweep angle?

No. Both sweep angle and engagement count are entered assumptions.

Are forward and reverse speeds necessarily equal?

No. Historical forms with different inner and outer tooth-circle radii have different speeds in the two directions.

Does the animation define the guide groove?

No. It is a schematic state path only.

Historical and institutional references

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: