A link belt joins individual segments into a continuous loop around two pulleys. Compare the pulley diameters to see their ideal speed and torque ratios, then explore the force-resolution geometry of a V groove.
Link Belt and Pulley Geometry Calculator
Vary driver and driven pitch diameters and the illustrative groove angle. Ratio outputs assume no slip and no loss. The groove-angle output is only the ideal geometric factor 1/sin(alpha/2); it is not friction, grip, capacity or efficiency.
Equation Used
- Pitch diameters are used and slip is zero for the kinematic ratio.
- Ideal torque ratio is the inverse speed ratio with no losses.
- The groove term is a force-resolution geometry only; friction and belt capacity are not calculated.
- The illustrated center distance, link pitch and playback period are layout choices, not selected hardware dimensions or running speed.
Change either pitch diameter to compare ideal speed and torque ratios. The animation shows modular links and a separate groove cross-section; it does not calculate belt capacity.
Joined links and contacting pulleys
A modular link belt joins individual links into a loop. The animation uses the entered pitch diameters on one scale, with straight external tangents joined to circular pulley wraps. Every displayed link follows that same closed path. Both pulleys turn in the same direction and their pitch-surface speeds equal belt speed.
The small tabs face inward and trail the direction of travel. Their shapes and spacing are schematic. Center distance changes automatically for a readable layout; it is not an installation dimension or a belt-length selection. The V-groove inset responds to the illustrative included angle and is separate from the pitch-plane view.
Comparing pulley ratios
The page can compare ideal driver/driven speed and visualize modular-link construction. Actual belt profile, pulley compatibility, minimum diameter, installation tension and service suitability must come from the applicable manufacturer catalog and installation instructions.
Ideal ratio and force-resolution geometry
Under a lossless no-slip assumption, ideal torque ratio is the same diameter ratio. The separate term 1/sin(alpha/2) describes only ideal sidewall normal-force geometry in a symmetric V groove; it is not a grip or capacity multiplier.
Ratio example
With 200 mm driver and 400 mm driven pitch diameters, the ideal speed ratio is 2:1 and the driven sheave turns at 50% of driver speed. No transmitted power, tension, efficiency or service margin follows from that ratio alone.
Model boundary
Real behavior depends on coefficient of friction, wrap angle, tight/slack tension, installation tension, belt section and construction, pulley diameter, speed, alignment, service factor and manufacturer correction tables. Groove angle is illustrative unless tied to a compatible catalog profile.
Link-belt geometry questions
Does the wedge factor predict grip?
No. It is only an ideal geometric normal-force factor; friction and capacity need additional manufacturer data.
Why do both pulleys turn the same way?
The belt is open, not crossed. Both pitch surfaces follow the same belt path without slip in this model.
Can I order a belt from the illustrated link count?
No. Center distance and link detail are drawing choices. Select a compatible belt profile, pulley dimensions and installed length using the manufacturer instructions.
Manufacturer references
- Gates Heavy Duty V-Belt Drive Design Manual: uses pitch diameters for actual speed ratio and treats capacity selection separately.
- Fenner POWERTWIST DRIVE installation instructions: documents individual link assembly, inward-facing trailing tabs and section-specific tensioning.
Building or designing a mechanism like this?
Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.