Interlocking Belt Lacing: Pull per Width Calculator | FIRGELLI

← Back to Engineering Library

This calculator converts an entered total belt-pull magnitude to pounds per inch of belt width and applies a user-entered multiplier. It does not select, rate or approve mechanical belt lacing.

Interlocking Belt Lacing Interactive Calculator

Convert total belt pull to force per inch of loaded width, then compare it with an entered multiplier.

0°

Entered Pull per Width
--
Multiplied Pull per Width
--
Multiplied Total Pull
--

Equation Used

entered pull per width=T/W; multiplied comparison=(T/W)SF; multiplied total=T SF
Scalar load normalization only. The entered pull basis and multiplier are user responsibilities; no fastener capacity is calculated.
  • Entered pull is a consistently defined total longitudinal belt-force magnitude distributed uniformly across entered width.
  • Width is the effective loaded belt width in inches.
  • The multiplier is a user-entered comparison factor, not a prescribed safety factor.
  • No belt rating, carcass/cover construction, thickness, fastener series/size/material, hinge pin, pulley diameter, troughing, impact, start/stop transient, fatigue, installation quality, environment, inspection or guarding model.

The multiplied pull per width is entered pull divided by entered width and multiplied by the entered factor. Actual fastener selection must follow the belt and fastener manufacturers' current tables for belt construction, thickness, pulley diameter, tension definition and service conditions.

Same mechanism and inputs as the interactive calculator.

Load normalization only

Dividing entered total pull T by effective belt width W expresses the same load as pounds per inch of width. Multiplying by an entered factor SF creates a comparison target.

The drawing is a schematic illustration of a belt joint. Its changing gap is not a calculated deformation or a model of how a real lacing product carries load.

Use as a units check

The arithmetic can normalize a known force across a known width before consulting authoritative selection data. It cannot establish working tension, calculate splice capacity or approve an installation.

Pull per width and multiplied load

Pull per width is T/W. Multiplied pull per width is TSF/W. Multiplying that result back by width gives TSF, so the third tile contains no independent splice-capacity model.

Worked example

For entered pull 7,200 lbf and width 36 in, pull per width is 200 PIW. With entered multiplier 1.5, the comparison is 300 PIW and multiplied total is 10,800 lbf. None of those numbers is a fastener rating.

What fastener selection requires

Use the belt and fastener manufacturer’s selection data for the actual belt construction, thickness, tension, pulley diameter and service conditions. Starting and braking loads may exceed steady running pull. This arithmetic supplies no fastener rating and cannot confirm splice life or installation suitability.

Questions

Is the multiplied PIW a fastener capacity?

No. It is only a user-entered load times a multiplier divided by width.

Does the calculator choose a lacing product?

No. Use current belt and fastener manufacturer selection data.

Is one multiplier suitable for all conveyors?

No. The correct load cases and design factors depend on the complete system and applicable requirements.

References & Further Reading

  • Wikipedia contributors. Conveyor belt. Wikipedia

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: