A clipper shears material between a moving toothed cutter and a fixed comb. Hiscox’s horse clipper uses handle motion to move the cutter across the fixed blade. The calculator illustrates a separate ideal rotary-eccentric drive, finding its radius and sinusoidal peak cutter speed from full stroke and complete-cycle rate.
Horse Clipper Interactive Calculator
Explore the ideal geometry of a rotary eccentric driving a laterally guided cutter. Treat the entered rate as complete eccentric revolutions per minute.
Equation Used
- Entered stroke is full peak-to-peak cutter travel.
- Entered rate is complete eccentric revolutions or reciprocating cycles per minute.
- Rigid eccentric and perfectly lateral, backlash-free guide.
- No force, torque, friction, blade contact, cutting, heat, vibration, wear, electrical, product-specific or animal-care model.
Check a manufacturer's definition before entering a published strokes-per-minute value: some sources count complete reciprocating cycles while others may count individual strokes. No product rating or operating recommendation is implied.
Ideal eccentric-to-slider motion
A pin offset by eccentric radius e rotates with the shaft while a guide constrains the cutter to lateral translation. In the ideal sinusoidal model, a full revolution produces one complete outward-and-return cycle and the cutter travels a peak-to-peak stroke S=2e.
The animation illustrates an ideal sinusoidal displacement; it is not a construction drawing of Hiscox’s hand-operated clipper or a particular powered product. Its displayed size and playback speed are fixed for viewing, while the numerical results respond to the inputs.
Use as a kinematics check
The identities can translate an entered full stroke and complete-cycle rate into eccentric radius and ideal peak cutter speed. They do not compare products or establish suitability for grooming, veterinary preparation or any animal.
Sinusoidal velocity
For displacement x=e cos(theta), peak speed is e omega. With e=S/2, omega=2piN/60 and S converted from millimetres to metres, vmax=pi S N/60,000 m/s.
The rate N must mean complete cycles per minute. Verify how a source defines ‘strokes per minute’ before using its number.
Worked example
For a 3.0 mm full stroke, the eccentric radius is 1.5 mm. At 2,400 complete cycles/min, the ideal sinusoidal peak cutter speed is pi×3.0×2,400/60,000≈0.377 m/s. Average absolute speed is a different quantity: 2SN/60,000=0.240 m/s.
Scope and limitations
Real mechanisms have connecting geometry, clearances, compliance, friction, imbalance and load-dependent speed. Cutter force, blade contact pressure, tooth geometry, lubrication, temperature, noise, vibration, wear, motor torque, electrical safety, cleaning and animal handling are outside this model. Follow the actual manufacturer's instructions and appropriate animal-care guidance.
Questions
Is peak speed the average cutting speed?
No. Sinusoidal speed varies continuously and reaches zero at each reversal.
Does one stroke mean one revolution?
The calculator defines one complete reciprocating cycle as one eccentric revolution. Published product terminology may differ.
Can this select a clipper or blade?
No. It calculates only ideal unloaded kinematics.
Historical source and kinematic basis
Gardner D. Hiscox, Mechanical Movements, Powers, Devices and Appliances, entry 1538, describes a hand-operated horse clipper whose moving comb-tooth cutter slides across a fixed cutter.
The separate rotary example uses x = e cos θ. Differentiating gives peak speed eω; a peak-to-peak stroke S = 2e gives the displayed formula. These geometric identities do not establish cutting performance or suitability for animal care.
Building or designing a mechanism like this?
Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.