TV Lift Kits Firgelli Robots Linear Slides Makezilla CA Site

Speed Controller for Linear Actuators

Speed Controller for Linear Actuators


$32.00 $39.00


Speed controller for linear actuators. Want to control your Linear Actuator motor or DC gear motor speed? then this is the ideal product to do that. This will adjust the speed by adjusting voltage down to as low as 3vdc but still maintain the same current draw for the actuator or motor.

Please note if you adjust the speed it will also change the speed when you reverse the actuator. If you want to change the speed in both directions then you need to use the FA-SC2 

Includes black case


The Firgelli Automations Speed Controller allows you to control the speed of our FA-RMS, FA-PO-35, FA-PO-150, FA-35-S, FA-RA, FA-150, FA-240, FA-04, FA-05, FA-200-L, FA-400-L, FA-1000-L, FA-TR-35 and and all our gear motor products.

Designed using a motor controller and high frequency Pulse Width Modulation (PWM) you are able to control the speed of your Actuator/Motor in either direction with minimal impact on the force output.   The speed controller will allow you to slow the actuator down, but not increase the speed beyond the speed at which it runs with no controller.

The FA-SC1 is intended to control the speed of one Linear actuator or motor, Do not connect two actuators/motors to the same FA-SC1. The slowest the actuator/motor will run is about 10% of the full speed.  Reducing the speed can affect the maximum load the actuator can move.


  • Model # FA-SC1
  • 12V-16VDC
  • No loan output current: 43mA
  • Stand-by current in armed state: lower 15.7mA
  • Output Voltage: 12V
  • PWM Signal: 10KHz
  • Output current 0 to 6A
  • Dimensions: 80mm x 70mm x 1,6mm
  • Operating Temperature Range -40 to + 80 degrees C
  • 10% to 100% speed range
  • Quiet due to higher PWM frequency

Customer Reviews

Based on 1 review Write a review

Contact Us for Expert Advice

Monday to Friday 9am to 5pm Pacific.

EmailCall 1-866-226-0465