A worm-driven wheel turns a feed roll, converting each worm revolution into a smaller roll rotation and a length of material feed. Compare tooth count, worm starts and roll diameter to explore the ideal feed distance.
Worm-and-pinion Feed Roll Drive Interactive Calculator
Enter wheel teeth, worm starts, roll diameter and an assumed wheel backlash angle. Compare reduction ratio, roll rotation and ideal feed per worm revolution.
Equation Used
- Inputs are user-supplied scenario values.
- The displayed equations are evaluated directly.
- Entered efficiencies, shares, limits and factors are not predicted.
- The visual is schematic and not dimensional.
- Strength, fatigue, wear, variation, controls and safety compliance are omitted unless explicitly calculated.
How the Worm-and-pinion Feed Roll Drive Works
The worm turns the wheel and its attached roll. Material feed follows the roll circumference when the material moves with the roll without slip. The drawing is schematic and does not show tooth contact or material deformation.
What This Calculator Represents
Feed assumes that the material follows the roll without slip. Backlash is an input, not a predicted clearance. Tooth strength, roll traction, material stretch, drive torque and self-locking are not calculated.
Calculation Method
Reduction ratio = wheel teeth / worm starts. Roll rotation per worm revolution = 360° / reduction ratio. Feed per worm revolution = π × roll diameter / reduction ratio. Circumferential slack from backlash = π × roll diameter × backlash angle / 360°.
How to Read the Result
Change one input at a time to compare its effect. Apply the assumptions stated beside the equations when interpreting each result.
Assumptions and Limits
Feed assumes that the material follows the roll without slip. Backlash is an input, not a predicted clearance. Tooth strength, roll traction, material stretch, drive torque and self-locking are not calculated.
Frequently Asked Questions
Does this calculate actual material feed?
It calculates ideal feed from roll circumference and rotation. Slip, material stretch and roll deformation can change actual feed.
Is the backlash angle calculated from the gear teeth?
No. You enter the backlash angle. The calculator converts that angle into circumferential slack at the roll.
Is the drawing suitable for manufacturing?
No. It is a schematic explanation and does not specify manufacturing dimensions, tolerances or materials.
Can these results establish a safe working load?
No. Strength, fatigue, wear, operating conditions and the complete assembly must be assessed separately.
References
Building or designing a mechanism like this?
Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.