Whitworth Quick Return: Ideal Crank-angle Timing Calculator

← Back to Engineering Library

A quick-return mechanism uses different portions of a crank revolution for its working and return strokes. Compare those ideal time intervals here with a constant-speed angular model; the complete linkage and slider stroke are not calculated.

Linear actuator checks for Whitworth Quick Return Mechanism

An actuator-driven version of whitworth quick return mechanism should be reviewed for stroke, linkage angle, and peak force. The mechanism may feel light through most of the travel and still bind or spike in force at one position.

With leverage, force is traded against travel. A bracket change that improves force can also increase required stroke, slow the output motion, or move the actuator into a poor mounting angle.

If the application needs synchronized motion, feedback should be treated as a requirement rather than an accessory. Two open-loop actuators wired together can drift apart when friction, load, or mounting geometry differs between sides.

  • Map actuator stroke to the actual output travel before choosing a model.
  • Check for binding, changing leverage, and peak load near the ends of travel.
  • Decide whether timed motion is acceptable or position feedback is required.

For a FIRGELLI design review, calculate the load case with the FIRGELLI actuator force calculator and plan the switching or controller arrangement with the linear actuator wiring diagram generator. If an actuator or cylinder is already installed, the linear actuator replacement finder helps keep the comparison tied to real dimensions.

Whitworth Quick Return Mechanism Interactive Calculator

Enter the radius and offset used in the displayed ratio, plus constant crank speed. The arcsine relation requires d/r below one. Larger entries are limited to just below one, so the displayed result does not establish that those dimensions can be assembled.

0°

Ideal angular-time ratio
--
Cut-sweep time
--
Return-sweep time
--
asin(clipped d/r)
--

Equation Used

x=clip(d/r,0,0.999999); alpha=asin(x); cut sweep=180+2alpha; return sweep=180-2alpha; times=(sweep/360)(60/N).
These results compare crank-angle timing only. They do not determine slider stroke, solve the complete linkage or establish whether the entered geometry can be assembled.
  • Input turns at constant speed.
  • The calculator uses d/r exactly as shown and clips it below one.
  • Cut and return occupy complementary crank sweeps.
  • No slider displacement or velocity is solved.
  • Link lengths, clearance, forces, inertia, strength and safety are omitted.
Same mechanism and inputs as the interactive calculator.

Whitworth Crank-angle Timing

The displayed arcsine relation divides a constant-speed revolution into working and return intervals.

What This Calculator Represents

An ideal crank-angle timing partition, not full linkage synthesis.

Timing comparison

x=clip(d/r)
alpha=asin(x)
beta_c=180+2alpha
beta_r=180-2alpha
t=beta(60/N)/360

Worked Scenario

At d/r=0.5, alpha is 30 degrees, so cut and return sweeps are 240 and 120 degrees and the ideal time ratio is 2:1.

Assumptions and Limits

Calculated: angular timing. Not calculated: closure, stroke, displacement, loads or design feasibility.

Frequently Asked Questions

Is stroke calculated?

No.

What happens when d/r reaches one?

The calculator limits the ratio to just below one so the arcsine stays defined. That numerical limit does not make the entered dimensions feasible.

Is speed constant?

Yes.

Are link lengths solved?

No.

Are forces included?

No.

Can this design a machine?

No.

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: