Variable Rotary Motion: Ideal Equal-ellipse Gear Speeds

← Back to Engineering Library

This model uses a matched equal-ellipse pitch pair with fixed focus spacing and a phase-dependent ideal ratio.

Variable Rotary Motion Interactive Calculator

Enter speed, ellipse size, eccentricity and phase. The paired pitch curves show the cyclic ideal ratio; tooth geometry, loads and losses are omitted.

0°

Ideal instantaneous ratio
--
Ideal instantaneous output speed
--
Ideal minimum output speed
--
Ideal maximum output speed
--

Equation Used

k=(1-e)/(1+e); ratio=k/(cos²(theta/2)+k²sin²(theta/2)); Nout=Nin ratio.
This is ideal non-circular pitch-curve kinematics, not a manufacturable tooth design or capacity rating.
  • Matched equal elliptical pitch curves rotate about fixed foci.
  • Ideal no-slip contact is assumed.
  • Tooth flanks, backlash, stress, friction, efficiency and safety are omitted.
Watch the Variable Rotary Motion in motion
Video: #035 Variable Rotary Motion – Elliptical Gear – 507 Mechanical Movements 3D Animation by Nguyen Duc Thang (thang010146) on YouTube. Used here to complement the diagram below.
Same mechanism and inputs as the interactive calculator.

Equal-Ellipse Variable Rotary Motion

Matched elliptical pitch curves rotate about fixed foci. Their local pitch radii change with phase, producing a cyclic output speed from steady input.

What This Calculator Represents

The tool reports the ideal instantaneous, minimum and maximum output speeds for the entered equal-ellipse geometry.

Ideal Equal-Ellipse Relation

k=(1-e)/(1+e)
ratio=k/[cos²(theta/2)+k²sin²(theta/2)]
Nout=Nin ratio

Worked Example: Ideal Equal-ellipse Speed Variation

Take a constant input speed of 180 rpm and eccentricity e = 0.30. The calculation gives k = (1 - 0.30)/(1 + 0.30) = 0.53846.

  1. At total input phase 0 degrees, the ideal ratio is k, giving an output speed of 96.9 rpm.
  2. At total input phase 180 degrees, the ideal ratio is 1/k, giving an output speed of 334.3 rpm.
  3. The maximum-to-minimum output-speed ratio is 1/k squared, approximately 3.45:1.

Total phase includes the entered phase and the advancing animation phase. Pause and return the animation to its start to compare these phase values. Changing ellipse size scales the pitch-curve drawing without changing this normalized ratio.

These numbers describe ideal angular speeds. Cutter speed, workpiece timing, torque, tooth contact stress, wear and service life require additional geometry and load data; they cannot be established from this example.

Model Boundary

Pitch-curve kinematics only. Tooth generation, undercut, contact stress, backlash, efficiency, loads and safety require separate engineering.

Frequently Asked Questions

Does phase change speed?

Yes.

Does e=0 give constant speed?

Yes.

Are teeth designed?

No.

References

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: