A planar three-link chain counted with one fixed ground link has six unconstrained moving-body freedoms. Two ideal one-degree-of-freedom lower pairs form an open two-DOF chain; adding a third lower pair closes the triangle and gives zero generic mobility under the Kutzbach count.
Three-link Kinematic Chain Interactive Calculator
The link count is fixed at three including ground. Select two lower pairs for an open chain or three for a closed triangular chain; results are generic mobility counts, not a dimensional motion solution.
Equation Used
- The ground link is included in n=3.
- All joints are ideal one-DOF planar lower pairs and each removes two independent freedoms.
- The selected topology is connected: j1=2 is open and j1=3 closes one triangular loop.
- Link dimensions, joint placement, singularities, redundant constraints, clearance, deformation, force and dynamics are omitted.
Three Links Including Ground
This page counts the fixed ground as one of three planar rigid links. Two lower-pair joints connect the two moving links in an open serial chain. A third lower pair closes the remaining endpoints into one triangular loop.
Revolute and prismatic lower pairs each allow one relative planar freedom and therefore remove two of the three relative planar freedoms.
What This Calculator Does
The calculator compares the two connected topologies available in this restricted three-link model. It reports the generic Kutzbach count and its arithmetic components.
It does not solve position, workspace, singularities, forces or the geometry of any excavator, robot or engine.
Generic Planar Mobility Count
n = 3
j1 = 2 or 3
The open case gives M=2. Closing the triangle with a third lower pair gives M=0 for generic geometry.
Worked Topology Comparison
With n=3 and j1=2, the two moving bodies begin with six planar freedoms and the joints nominally remove four, leaving M=2.
With j1=3, nominal constraints rise to six and the generic count becomes M=0.
Model Boundary
- Calculated: topology-level generic planar mobility for three links and two or three one-DOF lower pairs.
- Shown: open serial and closed triangular schematic topologies.
- Not calculated: position, reach, path, singularity, special geometry, redundant constraints, higher pairs, joint limits, backlash, deformation, velocity, force, torque, stress or control.
Frequently Asked Questions
Does the count include ground?
Yes. The fixed ground is one of the three links.
Why does the open chain have two DOF?
Each of its two ideal lower pairs contributes one independent joint coordinate.
Why does the closed triangle have zero mobility?
For generic dimensions, its three lower pairs impose six nominal constraints on six moving-body freedoms.
Can special geometry change the answer?
Yes. The simple count assumes independent generic constraints.
Does M=2 define the end-point path?
No. Link lengths and joint coordinates are required.
Does the calculator size actuators?
No.
References
- MIT OpenCourseWare, 2.007 Design and Manufacturing I, Lecture 6: planar mobility criteria and the Kutzbach count.
- Rothenhofer et al., Precision Engineering 34 (2010): M=3(n-1)-2j for planar lower-pair mechanisms.
- Wampler et al., Mechanism Mobility and a Local Dimension Test: limits of topology-only Grübler-Kutzbach counts and special geometry.
Building or designing a mechanism like this?
Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.