Brown movement 43 illustrates shallow, bevel-like toothed members transmitting rotation between oblique shafts. Explore this second gear form and calculate ideal driven speed, tooth-count ratio and mesh-event rate.
Form-2 Tooth-Count Calculator
Enter declared driver and driven tooth counts, driver speed, and schematic shaft angle and separation. The worksheet reports ideal tooth-count ratio and mesh-event rate only; it does not generate the historical tooth surfaces or rate a drive.
Equation Used
- The two declared tooth counts define one ideal external gear ratio with opposite rotation.
- Every declared driver tooth produces one ideal mesh event per driver revolution, giving fmesh=z1 n1/60.
- Shaft angle and separation are schematic display values and do not define manufacturable tooth surfaces.
- Pitch cones, apex locations, tooth traces, pressure angle, face width, undercut, interference, backlash, contact path, sliding, thrust, losses, lubrication, heat, loads, bearings, strength, wear, manufacture and safety are excluded.
The shallow flared members illustrate the second oblique-shaft gear form. Tooth counts set the ideal ratio, while shaft angle and separation adjust the schematic only.
Shallow bevel-like gears connect oblique shafts
Brown movements 42 and 43 are paired as two different gear forms for transmitting rotary motion between shafts arranged obliquely. The movement 43 engraving shows two shallow, flared toothed members; movement 42 is the distinct crossed cylindrical form.
The form 2 schematic shows the flared members and their ideal opposite rotation. Shaft angle and separation are display settings rather than a complete tooth system.
A historical oblique-shaft transmission form
The pair illustrates a way to transfer rotation between oblique shafts. Applying it to a working drive requires a defined tooth system, mounting geometry and operating loads beyond the ideal ratio calculation.
Ideal tooth-count relationships
The negative sign records opposite ideal external-mesh rotation. These identities do not calculate the historical tooth surfaces, pitch cones or sliding.
Declared tooth-count example
For z1=24, z2=48 and n1=720 rpm, ideal driven speed is -360.0 rpm, reduction magnitude is 2.000:1, driven revolutions per driver revolution are -0.500 and the ideal mesh-event rate is 288.0 Hz. The 60-degree angle and 24 mm separation are schematic.
Ratio and gear-surface geometry
The tooth-count relationships describe ideal speeds and mesh-event frequency. They do not generate pitch surfaces or tooth traces, establish compatible mounting positions, or predict sliding and load capacity. Those checks need the complete gear geometry and operating conditions.
Oblique-shaft form 2 questions
Is movement 43 a dimensioned hypoid axle?
No.
Do shaft angle and separation determine the ratio here?
No. They change the schematic only; the ideal ratio comes from declared tooth counts.
Does this calculate tooth contact, sliding or lubricant need?
No.
Oblique-shaft gear references
- Henry T. Brown, Five Hundred and Seven Mechanical Movements, page 17, movements 42 and 43: primary public-domain plate and caption identifying two gear forms for obliquely arranged shafts.
- 507movements, movements 42 and 43: accessible reproduction of the public-domain engraving and caption.
Building or designing a mechanism like this?
Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.