Flip Down TV Lift project

Flip Down TV Lift project.

This home owner wanted to flip a TV down from the horizontal plane to viewing angle at the touch of a button. With only 8" of space in the ceiling we decided that a rotating flip option would work best. First we designed a bracket to mount the 60" LED TV to and then use an FA-400-L-12-9" Actuator along with a Pull type gas spring to help with the pulling force. This allowed us to use a lower force and higher speed actuator. WE used a 2CH-REM to wireless control the actuator. Here are some pictures of the drawings we created for the bracket which is the most important part. We had this made out of aluminum for light weight and ease of manufacturing. a 12" Pull type gas spring was used which we also carry and a 12vdc power adapter that we also sell. The design of the Aluminum L-bracket is below and once this was made it took about half a day to install and cost about $1000 total to build the entire system with most of this ($500) for the Aluminum bracket we made for the customer.

 

 

 

 

Share this article

Featured Collections

0 comments

Leave a comment

Please note, comments must be approved before they are published

Need Help Finding the Right Actuator?

We precision engineer and manufacture our products so you get direct manufacturers pricing. We offer same day shipping and knowledgeable customer support.

Give us a call or email us and we'll be happy to help you find the best actuator for your project.