Slider-crank Reversing Mechanism: How It Works, Diagram, Parts, Formula and Uses Explained

← Back to Engineering Library

With crank radius normalized to R = 1 and rod ratio λ = L/R, the in-line slider position is x/R = cosθ + √(λ² − sin²θ). Travel from outer dead center is (λ + 1) − x/R, total stroke is 2R, and the slider reverses twice per crank revolution.

Normalized Slider-Crank · Reversal Reference

Explore exact normalized slider-crank position, travel and dead-center reversals.

0°

Normalized Stroke
--
Travel from Outer Dead Center
--
Position from Crank Pivot
--
Dead-Center Reversals
--

Equation Used

x/R=cosθ+√(λ²−sin²θ); travel/R=λ+1−x/R; stroke/R=2.
Exact normalized planar kinematics only; dynamics, loads, clearance and ratings are not predicted.
  • Crank radius is the normalization unit R.
  • Rod and crank are rigid and the slider is on-axis.
  • Selected rod ratio exceeds one.
  • Dynamics, loads, friction, clearance and ratings are excluded.

Autoplay advances from the selected reference angle; output cards report the selected pose.

Watch the Slider-crank Reversing in motion
Video: Gear slider crank mechanism 1 by Nguyen Duc Thang (thang010146) on YouTube. Used here to complement the diagram below.
Same mechanism and inputs as the interactive calculator.

Normalized exact loop closure

The visual preserves a one-unit crank, the selected normalized rod length and an on-axis slider. The selected angle sets the reference pose; autoplay advances from it while retaining exact member lengths and dead-center limits.

What the calculator determines

Select rod ratio and reference crank angle. The calculator reports normalized stroke, travel from outer dead center, position from the crank pivot and the two dead-center reversals per revolution.

Normalized in-line geometry

x/R = cosθ + √(λ² − sin²θ); travel from ODC = λ + 1 − x/R; stroke/R = 2.

Selected-input arithmetic

For λ = 4 and θ = 180°, the slider is at 3R from the pivot and has traveled 2R from outer dead center.

Kinematics only

The model excludes dimensional size, speed, velocity, acceleration, dwell tolerance, inertia, loads, friction, clearance, stress, fatigue and ratings.

Questions

Why are there two reversals?

The slider reverses at the inner and outer dead centers once each per crank revolution.

Are the outputs dimensional?

No. Distances are normalized by crank radius R.

References & Further Reading

  • Wikipedia contributors. Slider-crank linkage. Wikipedia

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: