Compare the ideal speed ratio for a fixed outer ring and an inner member driven by an eccentric input. Enter positive integer counts with the inner count smaller than the ring count. The calculation does not define complete tooth, lobe or output geometry.
Hypocyclic Gear Train Interactive Calculator
Explore tooth/lobe-count difference and the magnitude relation |output/input|=(Zring−Zplanet)/Zplanet for the assumed fixed-ring convention.
Equation Used
- Counts are rounded to integers and valid only for 0<Zplanet<Zring.
- Fixed outer ring, eccentric input and opposite-direction rotation of the inner member, using the stated count-difference relation.
- Reported speed and angle are magnitudes; direction reversal is disclosed separately.
- No module/pitch, generating geometry, eccentricity, pin diameter/circle, tooth/lobe profile, clearances, output mechanism, load sharing, stress, efficiency, backlash, lubrication or life model.
The outputs are magnitudes; the commonly assumed output direction is opposite the eccentric/input rotation. Count validity alone does not prove that profiles, pin circles, eccentricity, bearings or output-pin geometry can be built.
Fixed-ring count-ratio model
For valid positive integer counts with Zplanet<Zring, define ΔZ = Zring − Zplanet. The fixed-ring relation gives an input/output speed-ratio magnitude of Zplanet/ΔZ and an output/input magnitude of ΔZ/Zplanet.
The animation shows a qualitative eccentric, counter-rotating inner member. It is not generated tooth or lobe geometry.
Use as a count-ratio check
A small count difference gives a large input/output speed ratio. If the ratio falls below one for the entered counts, the ideal relation describes speed increase rather than reduction. Count arithmetic alone cannot establish mesh feasibility, profile geometry, output-pin motion or torque capacity.
Magnitude and direction
The displayed angle is 360ΔZ/Zplanet degrees of output rotation per input revolution. It is a magnitude; under this fixed-ring convention the output turns in the opposite direction to the eccentric input.
If counts are equal or reversed, the physical convention is invalid and ratio outputs are zero.
Worked count-ratio example
For ring count 40 and inner lobe count 39, DeltaZ=1, reduction magnitude is 39:1, output magnitude is 1/39≈0.02564 revolution or 9.23 degrees per input revolution, in the opposite direction under the assumed convention.
Scope and limitations
A real reducer requires a defined mechanism topology, generating curve and pitch geometry, ring pin/tooth and disc lobe profiles, eccentricity and clearances, bearing and output-pin geometry, multi-disc phasing, contact ratio and load sharing, materials/heat treatment, contact and bending stress, deflection, efficiency, backlash, lubrication, thermal behavior, fatigue and manufacturing tolerances.
Questions
Does a one-count difference guarantee a working reducer?
No. It gives only a nominal ratio; full geometry is required.
What is the output direction?
Opposite input under the assumed fixed-ring convention.
Does the ratio predict torque capacity?
No. Strength, efficiency and load sharing are absent.
Calculation basis and reference
The assumed fixed-ring model gives a signed output/input speed ratio of −(Zring − Zplanet)/Zplanet. The results show its magnitude and reciprocal. When the counts differ by one, the input/output reduction magnitude equals the inner lobe count.
Sumitomo Drive Technologies’ explanation of cycloidal gearing describes reverse rotation of a disc within a fixed pin ring and transfer of that reduced rotation to an output shaft. The count arithmetic here does not generate the disc profile, eccentric or output-pin geometry.
Building or designing a mechanism like this?
Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.