This calculator is a simplified displacement-ratio scenario: pump displacement is assumed linear with swash-angle fraction, loop flow is transferred with no volumetric loss, and motor torque uses a fixed 90% factor. It does not predict a real hydrostatic transmission.
Hydrostatic Transmission Interactive Calculator
Explore signed geometric flow/speed and a pressure-displacement torque magnitude under explicit idealized assumptions.
Equation Used
- Entered pump displacement is the magnitude at ±18 degrees and varies linearly through zero with entered angle.
- Motor displacement is fixed; all signed pump flow reaches the motor with 100% volumetric efficiency.
- Pressure input is differential magnitude and torque uses a fixed 0.90 multiplier independent of operating point.
- No charge circuit, leakage, case drain, relief, pressure losses, compressibility, inertia, acceleration, thermal balance, cavitation, overspeed, component map, controls or rating model.
The fixed 90% factor affects torque only; volumetric efficiency is implicitly 100%. Actual efficiency varies with pressure, speed, temperature, displacement fraction and hardware, and cannot be represented by this single value.
Simplified signed displacement ratio
The model defines effective pump displacement as entered full displacement multiplied by theta/18 degrees. Multiplying by input RPM gives signed ideal flow; dividing by motor displacement gives signed ideal motor speed.
The diagram is a qualitative loop illustration. Its rotating symbols are not tied to the calculated speed ratio and continue moving at zero calculated flow; use the numerical results to compare flow and speed. Piston kinematics, valve plates and circuit dynamics are not modeled.
Use as a ratio and unit check
The scenario can illustrate reversal through zero swash and pump/motor displacement ratio. It cannot size components, predict vehicle speed, determine tractive effort or establish an operating envelope.
Mixed ideal and assumed-efficiency model
Flow and speed use 100% volumetric transfer. Torque magnitude uses DeltaP Dm/(2pi) multiplied by a fixed 0.90. Power magnitude is |torque omega|. Because real volumetric and mechanical efficiencies vary and pressure depends on load and relief behavior, these are not performance predictions.
Worked displacement-ratio example
At +18 degrees, 50 cc/rev pump and motor, 3,000 rpm and 5,000 psi differential, signed ideal flow is 150 L/min and ideal motor speed is 3,000 rpm. With the fixed 90% torque factor, torque magnitude is about 246.9 N·m and power magnitude about 77.6 kW.
Scope and limitations
Real hydrostatic design requires manufacturer pump/motor maps versus displacement, pressure, speed, viscosity and temperature; charge pressure and boost flow; case drains and leakage; relief/cross-port valves; line losses and hose ratings; cavitation and minimum inlet conditions; swash controls and neutral stability; inertia, braking and overrun loads; thermal rejection; shaft/coupling limits; filtration, contamination, overspeed protection and complete machine safety analysis.
Questions
Is displacement always linear with swash angle?
No. This is an explicit simplifying assumption for the scenario.
Does zero angle guarantee neutral?
No. Real null bias, leakage and controls are absent.
Is 90% a verified efficiency?
No. It is a fixed illustrative torque multiplier.
Calculation basis
The model defines pump displacement as the entered full displacement multiplied by θ/18°. Pump displacement times input speed gives signed ideal flow; dividing that flow by motor displacement gives signed motor speed.
Torque magnitude is pressure difference times motor displacement per revolution divided by 2Ï€, then multiplied by an assumed 0.90 factor. Power is the absolute value of torque times angular speed. The linear displacement rule and fixed torque factor are illustrative assumptions, not verified component characteristics.
Building or designing a mechanism like this?
Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.