Flexible Coupling: Parallel and Angular Alignment Comparison | FIRGELLI

← Back to Engineering Library

The Zodel flexible coupling joins two shaft-mounted flanges through a continuous belt laced around their overlapping crowns. The animation shows an aligned end view of this historical construction. The calculator separately compares measured alignment values with limits entered for the actual selected coupling.

Flexible Coupling Interactive Calculator

Compare measured parallel and angular alignment values with limits copied from the exact selected coupling's current manufacturer documentation.

0°

Parallel measured/catalog ratio
--
Angular measured/catalog ratio
--
Signed parallel margin
--
Signed angular margin
--

Equation Used

parallel ratio=e/elim; angular ratio=a/alim; margins=limit-measured.
No force or stiffness is inferred from alignment measurements.
  • Measured and catalog values use matching conventions.
  • Entered limits apply to the exact product, size, element and operating conditions.
  • Parallel and angular results are reported separately, not combined into a pass/fail index.
  • No torque, speed, temperature, axial movement, reaction load, stiffness, fatigue or life model.

Separate ratios do not establish an allowed combined condition; use the manufacturer's combined-limit instructions when applicable.

Watch the Flexible Coupling in motion
Video: mechanism animation # 223 flexible coupling on YouTube. Related demonstration of a flexible coupling.
Same mechanism and inputs as the interactive calculator.

Belt-laced crowns

Each shaft carries a flange with an overhanging cylindrical crown. One crown lies inside the other. A continuous belt passes through the windows and around alternate crown seats, transmitting tangential force between the flanges. The end view uses illustrative proportions and shows aligned rotation; it does not calculate belt deformation under misalignment, tension or reaction forces.

Two separate catalog comparisons

Enter measured parallel offset and angular error, then enter the matching limits from the selected product documentation. Negative margin means the measurement exceeds that entered limit, but the calculator does not certify suitability.

Ratios and signed margins

Parallel ratio = e/elim and angular ratio = a/alim. Each signed margin is the entered catalog limit minus its measured value. These are separate comparisons; neither ratio determines coupling stiffness or bearing load.

Example

Measured 0.2 mm against an entered 0.5 mm limit gives 0.40× and 0.3 mm margin. Measured 0.5° against 1.3° gives 0.38× and 0.8° margin. Combined capacity still requires manufacturer guidance.

Applying the selected product limits

Lovejoy defines angular and parallel misalignment and directs users to manufacturer catalogs for actual values and torque derating. Catalog limits vary across coupling products.

This page does not model torque, speed, axial displacement, temperature, duty, service factor, combined misalignment, bearing reactions, coupling stiffness or service life.

Questions

Does this calculate bearing side load?

No.

Can the two ratios be combined by taking the larger?

No universal rule is assumed.

Are the default limits recommendations?

No. Replace them with exact product data.

References

Gardner D. Hiscox, Mechanical Movements, Powers, Devices and Appliances (1901), page 192, items 719–720: Zodel flexible coupling. Scientific American, 12 January 1901, page 21, describes the continuous leather or cotton belt laced through the two crowns. The manufacturer links below concern modern product-specific alignment limits.

Lovejoy engineering data: alignment definitions and direction to consult specific catalogs.

Lovejoy product catalogs: current product-specific data.

Building or designing a mechanism like this?

Explore the precision-engineered motion control hardware used by mechanical engineers, makers, and product designers.

← Back to Mechanisms Index
Share This Article
Tags: