TV Lift Project
Why Spend £1000 or more on a TV Lift mechanism when you can
build your own for a fraction of the cost. We have sold hundreds
of actuators just for this purpose. Here is what you need to
know and how to choose what actuator you need.
1. You need to decide what stroke length and force actuator
you need. The stroke length is the length the actuator moves
through. So as an example a 12" Stroke actuator will move 12",
but note that the length of the actuator when collapsed will be
about 5" longer than the stroke. So a 12" stroke actuator is
about 17" closed and 29" open (17"+12"). This is important as
when you come to install the actuator into your cabinet you will
need to make adjustments for the length. If you want a stroke
that we don't have you can add a micro switch into your system
to stop the actuator where you want it to
- To decide on the stroke you need to measure the
height of your TV, then round that up to the nearest stroke
size that we offer.
- To decide what force you need, just calculate the
weight of the total TV and mechanism, then round up to the
forces that we offer, typically you will use the standard
force (110lbs force) or the high force (165 lbs) or the super
high force (400 lbs force) Note that the 400lb force actuators
are a larger actuator, remember that when installing
2. You will need some type of TV mounting wall bracket if
your lifting a Plasma or LCD TV to mount the TV to. You can
typically buy these of the internet for around
£100 -
£200 each
3. You will need to buy 2 of our mounting brackets to attach
the actuator to, and then attach the brackets as show in the
diagram above to the back of your TV mounting bracket. For this
you will have to do some drilling and use screws and nuts to
attach them together.
4. Linear Guide rails will be needed to give the mechanism a
smooth straight lift. Linear guide rails are used as draw guides
and provide smooth linear motion. Make sure you buy heavy duty
types, used for industrial draws. Most hardware stores sell
these for around £30 per pair, and make sure the stroke is
equivalent or longer than the Actuator stroke that you have
chosen
5. You will need a remote control system that can be
purchased from our Actuator Accessories section, or a manual
rocker switch, also available from our Accessories section.
6. You need a power adaptor, again available from our
Accessories section or if we are out of stock you can buy from
most electrical stores, just ask for a 12vdc output with at
least 4amps output
Here is what you need to order for this project:
- One linear actuator, use instructions above to decide
on stroke and force, max stroke we have is 30" Note that the
actuators do not move once power is removed so you don't have
to worry about the TV falling once at the top of the stroke,
in addition the actuators have a built in limit switch at both
ends to cut the power to the actuator to protect itself.
- Mounting brackets, one on each end, these brackets will
then need to be attached to your base using and also to the
back of the TV bracket, typically towards the top.
- Manual rocker switch for a dash mounted switch, or
remote control
- Guide rails
- Power supply
- LCD/Plasma wall bracket
Wiring instructions can be seen on each individual page,
i.e., go to remote control system to see the wiring diagram, or
Manual Rocker switch etc. The Actuator does not have a wiring
diagram because it only has 2 wires
|
